Precautions for starting the extruder

With the country's strong promotion of the Reuse Principle of waste resources, plastic granulator, a key machine for the reuse of waste plastic resources, once again ushered in the new generation of the industry, But some customers, after purchasing the plastic granulator, are put into use soon after the installation according to the relevant introduction, never considering the feeling of the plastic granulator. To know that the cell phone battery in the early years still needs to be started up for maintenance, let alone a large machine, the first use should be more cautious.

The expert of single screw extruder service provider said that the first temperature rise is about 40-50 minutes before starting. Raise the temperature to the point where you can pull the motor V-belt by hand until it is free; pull the motor V-belt eight to ten times continuously according to the normal working direction. Then continue to heat up for about 10 minutes, and then start the machine, but continue to heat up, because normal production needs to continue to add heat; adjust different temperatures according to different properties of plastic.

When the plastic machine manufacturer reminds you to stop the machine, the main machine should be completely cut off the power supply. The head plug (with wrench) must be removed. Preheat separately before next use. The machine also needs daily use and maintenance, especially the first use must strictly comply with the regulations, and can be used blindly, so as to avoid reducing the life of the plastic granulator, or even causing irreparable damage to the plastic granulator.